PDA

View Full Version : HFS-3 in EVO VI

taiman
06-05-2010, 12:28 AM
Just added water and all this popped out
http://i913.photobucket.com/albums/ac337/taiman84/01032010027.jpg

after understanding what everything is and does i came across this problem, the tank outlet was already in place and the pump inlet didnt agree with it.
http://i913.photobucket.com/albums/ac337/taiman84/06032010033.jpg
http://i913.photobucket.com/albums/ac337/taiman84/29032010099.jpg

so i bought 6mm push in fittings to do this.
http://i913.photobucket.com/albums/ac337/taiman84/30042010252.jpg
taiman
06-05-2010, 12:31 AM
drilling of injection points, just before the throttle body
loctite ing in place
http://i913.photobucket.com/albums/ac337/taiman84/28042010236.jpg
http://i913.photobucket.com/albums/ac337/taiman84/28042010238.jpg

lower coldside piping picture
http://i913.photobucket.com/albums/ac337/taiman84/07052010267.jpg
taiman
06-05-2010, 12:39 AM
from the boot to the outside
http://i913.photobucket.com/albums/ac337/taiman84/30042010249.jpg

from the back to the front
http://i913.photobucket.com/albums/ac337/taiman84/30042010251.jpg

FAV mounting, underneath the engine bay chassis rail
http://i913.photobucket.com/albums/ac337/taiman84/30042010247.jpg

covering everything with split tube cable protectors
http://i913.photobucket.com/albums/ac337/taiman84/30042010245.jpg
http://i913.photobucket.com/albums/ac337/taiman84/30042010246.jpg


to be continued...
taiman
09-05-2010, 06:21 AM
used velcro to make it stay
http://i913.photobucket.com/albums/ac337/taiman84/08052010269.jpg

now just to mount the tank and tune
Richard L
09-05-2010, 09:28 AM
This install is well thought out. I didn't want to post earlier until you have finished. Congrets.

One the tank install, is there room for the level sensor?



Please test run the system before tuning.
taiman
11-05-2010, 11:59 PM
This install is well thought out. I didn't want to post earlier until you have finished. Congrets.

One the tank install, is there room for the level sensor?



Please test run the system before tuning.

thanks Richard,

if you have a closer look at the tank pictures, the level sensor is in place at the back end of the pump.
came pre-drilled and installed by Howerton Eng.
just waiting on anti-slosh foam now for further piece of mind.