CUSTOM AQUAMIST GAUGE?

[erm324]

Hey,

I currently own an E92 M3 with an ESS vt2-625 supercharger kit and I am looking to purchase the aquamist hfs-3 kit to aid in IAT suppression. I am curious if the bezel on the gauge could be customized? Here is my current gauge setup:
http://i42.tinypic.com/fmjqqf.jpg

I am looking to take the leftmost gauge out and replace it with the aquamist controller. I think the bezel around the aquamist gauge would ruin the appearance of my setup, so I was wondering if there was way the bezel around the aquamist gauge could be removed? Or could I have it customized to be 1/2 its original thickness? Or essentially altered in any other way in order to make it go with the look of my current setup. Thank you very much!

[Richard L]

what is the outside diameter of the gauge bezel?

[erm324]

I know that online it says the gauge is 52mm, I am not sure the diameter of it :( (and by thickness i mean if your looking at the gauge from its profile, not directly head-on - a better word would probably be the "depth," meaning im looking to have the gauge relatively on the surfact of the pod, and not look deeply recessed into the bezel)

[Richard L]

The transparent front protrudes further than the aquamist but the gauge face is recessed more than the aquamist gauge face.

This is the nearest match Howerton offers:
http://howertonengineering.com/wp-content/gallery/gauge-bezels/gauge-bezels.jpg

Can the deleted gauge bezel be separated from the body? Might just use the bezel for the aquamist gauge.


http://www.aquamist.co.uk/forum/gallery/DDS3v8/11.jpg

http://www.aquamist.co.uk/forum/gallery/DDS3v8/cmb-m.jpg