xga
01-11-2004, 09:29 AM
From what I've read on here, it seems as though 15% is the general amount of water to be injected in relation to fuel flow. Should this percentage increase or decrease if I use a 50/50 Water-Methanol mix or should it just stay the same?
I know it will probably be difficult to give an exact percentage due to the number of variables to consider, but a ball park figure would be a good starting point.
Thanks in advance.
I know it will probably be difficult to give an exact percentage due to the number of variables to consider, but a ball park figure would be a good starting point.
Thanks in advance.