Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

No but have friend who can or can use local company.

Is it the flow sensor table not being linked causing the issue?

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

Yes, the flow table must match the jet number. Until you have done the soldering, you can not set the faulsafe (SC, WL and WH) properly.

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

Ah!!!! My garage fitting hasnt done it correctly then!

Will get on the case!!

Should i also solder the pre amp to 2.5 ?

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

Why don't you send the controller back to me and I will get it done within the same day. I can also do some calibration for you on the 0.6mm jet.

Richard

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

Yeh that would be brilliant Richard thank you so much.

Just send the actual board to you yes, nothing else?

Cheers

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

just the board with the box for protection.

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

no worries, all padded up and in padded envelope to be send tomorrow morning recorded delivery signed for.

will you be in office on Tuesday morning or shall send to home address? PM me if home address is better.

cheers

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

I will be in the office on Monday and Tuesday this week.

ERL Ltd
Iroko house
Bolney Ave Peacehaven
East Sussex BN10 8HF

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

Perfect, will be with u by 1pm on Tuesday.

Re: Peugeot 207 GTI - HFS4 Finished Tomorrow
 

Write your return address inside.