Re: Map sensor or lack of?
yes Andrew
|
Re: Map sensor or lack of?
I saw the voltage of 0.771v at the ECU. it is quite low for the MAP sensor. It should be around 1.5v at pre-crank. Also check the continuity of the blue wire of the grey harness because the the same voltage was not appearing the the RJ connector.
|
Re: Map sensor or lack of?
yes the continuity has been checked the voltage is not making it from one end to the other. how else am I supposed to check it?
|
Re: Map sensor or lack of?
I suppose you can use the resistance option on the Fluke to probe the the two ends on the the blue wire. It should be near 0 ohms. One end on the gold figure of the RJ. May need to sharpen your probe.
|
All times are GMT +1. The time now is 06:16 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.