Engine control unit to Aquamistcontroller
 

i control the Aquamist controller via a map sensor. Unfortunately, my engine
control unit does not get along when water is injected and therefore the
engine is not running properly. I would now like to use my engine control
unit to control the Aquamist controller.
Unfortunately, I find in the manual no way.
What can I do?

Gunther

Re: Engine control unit to Aquamistcontroller
 

what can i do with the AUX-Input options?

Re: Engine control unit to Aquamistcontroller
 

I need the following information:

1. Serial number of the HFS4 controller?
2. What car model do you have?
3. Why spray with boost instead of IDC?

Re: Engine control unit to Aquamistcontroller
 

Hello,

1: SN:121970
2: Lotus Elise Rover VVC Turbodrive
3: how the boost works was clear to me. I don't understand IDC. How can I set the power-on limit?

Gunther

Re: Engine control unit to Aquamistcontroller
 

now the system runs over IDC. But it's still the same problem there

Re: Engine control unit to Aquamistcontroller
 

Remind me what is the problem with IDC.

Re: Engine control unit to Aquamistcontroller
 

when I drive at full throttle and then take some throttle out the engine starts to ring through the throttle and the lower water flow rate. That's why I had to take the ignition back.

Re: Engine control unit to Aquamistcontroller
 

are you running M50/W50?

Re: Engine control unit to Aquamistcontroller
 

running with Methanol 60/Water 40

Re: Engine control unit to Aquamistcontroller
 

thanks for the answer.

Two more questions:

1. What is the HP of the car
2. What is the fuel injector size.