Pontiac G8 GT
I'm curious on how i'm suppose to wire up my ECU connector for my HFS-3 module which is these instruction in the manual
2. Signal to the grey RJ48 connector: - Red ................. Ignition switched 12V - Green ............. Fuel injector (-) pin - Blue ..................MAP sensor (optional) attached is what i believe the ECM wiring pinout but each fuel injector has its own return (-) . so are are these internally connected so i can hook it to any injector fuel control wire ? I do see my MAP sensor Signal wire is Pin 58 so all i do is run that wire into my ecm on that pin??? just trying to figure this all out and cut cost on my installer trying to charge me an arm and a leg to do this. ECM DATA http://www.grrrr8.net/crazypaul/2008GTPinouts.pdf |
All times are GMT +1. The time now is 09:37 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.