HFS-3 in EVO VI
Just added water and all this popped out
http://i913.photobucket.com/albums/a...1032010027.jpg after understanding what everything is and does i came across this problem, the tank outlet was already in place and the pump inlet didnt agree with it. http://i913.photobucket.com/albums/a...6032010033.jpg http://i913.photobucket.com/albums/a...9032010099.jpg so i bought 6mm push in fittings to do this. http://i913.photobucket.com/albums/a...0042010252.jpg |
Re: HFS-3 in EVO VI
drilling of injection points, just before the throttle body
loctite ing in place http://i913.photobucket.com/albums/a...8042010236.jpg http://i913.photobucket.com/albums/a...8042010238.jpg lower coldside piping picture http://i913.photobucket.com/albums/a...7052010267.jpg |
Re: HFS-3 in EVO VI
from the boot to the outside
http://i913.photobucket.com/albums/a...0042010249.jpg from the back to the front http://i913.photobucket.com/albums/a...0042010251.jpg FAV mounting, underneath the engine bay chassis rail http://i913.photobucket.com/albums/a...0042010247.jpg covering everything with split tube cable protectors http://i913.photobucket.com/albums/a...0042010245.jpg http://i913.photobucket.com/albums/a...0042010246.jpg to be continued... |
Re: HFS-3 in EVO VI
used velcro to make it stay
http://i913.photobucket.com/albums/a...8052010269.jpg now just to mount the tank and tune |
Re: HFS-3 in EVO VI
This install is well thought out. I didn't want to post earlier until you have finished. Congrets.
One the tank install, is there room for the level sensor? Please test run the system before tuning. |
Re: HFS-3 in EVO VI
Quote:
if you have a closer look at the tank pictures, the level sensor is in place at the back end of the pump. came pre-drilled and installed by Howerton Eng. just waiting on anti-slosh foam now for further piece of mind. |
All times are GMT +1. The time now is 04:09 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.