waterinjection.info

waterinjection.info (http://www.aquamist.co.uk/forum2/vbulletin/index.php)
-   Aquamist HFS-3 forum (http://www.aquamist.co.uk/forum2/vbulletin/forumdisplay.php?f=34)
-   -   HFS3 V2KC default pcb setting (http://www.aquamist.co.uk/forum2/vbulletin/showthread.php?t=3075)

zakshaker 09-06-2017 06:05 PM

HFS3 V2KC default pcb setting
 
Hello,

I just got hand on a HFS3 V2KC board which was installed on a Mitsu L200 turbo diesel.
This PCB has gone thru few changes.

http://i394.photobucket.com/albums/p...t/IMG_5897.jpg

I would like to set it up back to factory setting (it is going on an evo3 now)

anyone would have a picture of same PCB with default setting ?
Or could you tell me what are the default settings ?

I'm pretty sure the MPS soldering has to be removed, then solder bridge IDC again (I think this has been cut)

now what about CUST, PWM-, PWM+
Then *1, *1.5, *2

thanks

Richard L 10-06-2017 08:11 AM

Re: HFS3 V2KC default pcb setting
 
factory:
MPS/IDC ........... IDC linked, MPS cut
PWM- ........... linked, all others unlinked
iDC prescaler .......... x1 linked

zakshaker 14-06-2017 06:54 AM

Re: HFS3 V2KC default pcb setting
 
Thanks Richard.

PWM- is well butchered, that's worry me !
I'll let you know how it goes

thanks for your help

Richard L 14-06-2017 08:33 AM

Re: HFS3 V2KC default pcb setting
 
That doesn't that bad. As long as the pads are there, you will be OK. Perhaps clear the flux with methanol.

zakshaker 14-06-2017 09:13 AM

Re: HFS3 V2KC default pcb setting
 
after closer inspection, the larger pad just when off the PCB just by contact with finger :/

Anything we could do to sort this out ?

http://i394.photobucket.com/albums/p...t/IMG_5980.jpg

Richard L 14-06-2017 12:50 PM

Re: HFS3 V2KC default pcb setting
 
http://www.aquamist.co.uk/forum/V2K.jpg

zakshaker 27-06-2017 08:24 PM

Re: HFS3 V2KC default pcb setting
 
Thanks Richard I will try that then.

I've tried to send an emails a week ago and an other one tosay. have you changed email address ?

zakshaker 05-07-2017 08:49 PM

Re: HFS3 V2KC default pcb setting
 
it seems to have done the trick. the led blinks again :)
Thanks for help as always.

I have well received your email, sent two others since then. Doesn't seem to be best way to reach you anymore.

cheers


All times are GMT +1. The time now is 12:22 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.