Engine bogging down at lower RPM
I ran the car on AMD Technics rollers on the 27th June; it showed that bellow about 2700rpm, the car made more torque without the water/methanol injection. From that point on, the torque was higher and thus the power also.
I am injecting about 1.1 ltr/min but I was suprised buy these results. I have aadjusted the controller to start injecting around 2500rpm now, so hopefully I'll be getting that little bit more out of her. |
Re: Engine bogging down at lower RPM
I though you have experienced more torque at low rpm before, I could have remembered it wrong.
|
Re: Engine bogging down at lower RPM
I was running 70% methanol on those runs and I got more all through out but with 50:50 I can feel it slow and then pick up again. Once it picks up i get more power through the rest of the range. I may get a second comtroller and hook it up to one of the three injectors to give a more pogressive introduction and limit the flow low down.
I'm in Arizona on holiday right now though :D |
All times are GMT +1. The time now is 02:20 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.