Location of the nozzle for caldina GT4 (3sgte)
Hai guys! im new here..
I just bought Aquamist System 1s for my Caldina GT-Four (ST246) version..My question is, where should i place the nozzle? is it between the throttle and the IC or between the IC and the Turbo? My problem is that both the throttle body and the turbo are very close to the intercooler...so im hoping for some advise and suggestion of where should be the best place i put the nozzle and how should i do it...http://upload4.postimage.org/1920859/Engine.jpg |
On your car, most of our users put the water jet in front of the intercooler whicj helps combating the heat soaked inetercooler.
|
Quote:
btw,where should i connect the switch wire (purple wire)? |
I mean to put the jet between the turbo and the IC.
The Purple switch wire should go to any switched 12V supply. Ignition key? |
Quote:
|
Ignition key normally switches most thing on. If I say innition switch, would it make better sense?
Basically, you need to connect the purple wire to a location where there is a 12v present upon turning the ignition key. |
yap..thanks mate..i got it...now,this is my problem...My IC are very close to the turbo..as you can see from the pic..so,should i make a hole on the rubber (for the nozzle)joining the IC and the Turbo?..it seem like there are no space in between..http://upload4.postimage.org/1938314/enginebay.jpg
|
Can you tap a hole on the inlet (end tank) of the IC?
|
Do you know of any websites for caldinas?
|
All times are GMT +1. The time now is 10:04 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.