waterinjection.info

waterinjection.info (http://www.aquamist.co.uk/forum2/vbulletin/index.php)
-   Aquamist systems in details and latest offerings (http://www.aquamist.co.uk/forum2/vbulletin/forumdisplay.php?f=47)
-   -   NEW product... checkvalve jets (http://www.aquamist.co.uk/forum2/vbulletin/showthread.php?t=2323)

Howerton Engineering 14-07-2013 03:43 PM

Re: NEW product... checkvalve jets
 
If you have an issue due to gravity or PD then they would help, but otherwise probably not needed.

Wolf_Tm250 15-07-2013 02:41 PM

Re: NEW product... checkvalve jets
 
Quote:

Originally Posted by Howerton Engineering (Post 19036)
If you have an issue due to gravity or PD then they would help, but otherwise probably not needed.

Ok, thank you!

vlopatin 08-06-2015 10:17 PM

Re: NEW product... checkvalve jets
 
Hello, have to of check valve jets installed before throttle into intercooler pipe. Suddenly got "error" lights in my HFS4 controller and find out that one of two nozzle stopped spraying... So my questions - is there any options to make it working back (what should I check)
Thanks in advance

Richard L 09-06-2015 08:25 AM

Re: NEW product... checkvalve jets
 
Quote:

Originally Posted by vlopatin (Post 21592)
Hello, have to of check valve jets installed before throttle into intercooler pipe. Suddenly got "error" lights in my HFS4 controller and find out that one of two nozzle stopped spraying... So my questions - is there any options to make it working back (what should I check)
Thanks in advance

Did you recalibrate the WL and WH after putting in extra, that is the impression I got from your post.

vlopatin 09-06-2015 10:09 AM

Re: NEW product... checkvalve jets
 
Quote:

Originally Posted by Richard L (Post 21594)
Did you recalibrate the WL and WH after putting in extra, that is the impression I got from your post.

Yes, I did. I had 2x0,5 standard type and several month ago changed them to 2x0,7 checkvalve - so it was ok till yesterday. It doesn't work even if I remove it from the pipe and run test (second one is ok)

Richard L 17-06-2015 08:27 AM

Re: NEW product... checkvalve jets
 
If you have one nozzles suddenly stop working, Open it up and check for debris. This is the only cause. Make sure you do it on a clean table top. Make sure every o-rings are seated properly during reassembling.


All times are GMT +1. The time now is 10:11 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.