New Install On VL Turbo
 

I've just bought a hfs-3 kit to install on my RB30 powered VL Turbo. I'm planning on putting the injectors post intercooler. Just wondering where the best position would be. I was thinking in the top side of the 90deg bend coming off the cooler. I've included a pic showing the piping.
Its currently making a shade over 300rwkw through an auto and big converter and using the injector size calculator I've come up with 2 x 1.0mm nozzles. Injectors are 750cc. Does this sound about right for something which should make close to 600 flywheel hp with the w/m kit installed?

http://www.aquamist.co.uk/HFS3/pics/RB30.jpg

Re: New Install On VL Turbo
 

That looks like quite the setup. Yes, two 1.0mm jets sounds like a good starting point based on the injectors and the HP level. Putting the jets at the exit of the IC looks to be the best position from the picture.

Re: New Install On VL Turbo
 

Another quick question. Is there a maximum distance that the FAV can be installed from the actual nozzles?

Re: New Install On VL Turbo
 

The closer the better. There's no set rule, but it does make a difference.