Need some help
 

I need to find out if i can replace C16 with a aquamist system.
If so which system and how many injectors?
I'm running an EVO 8 with 2150 cc injectors.
93 octane and C16. Do not wish to use E85.
Aquamist can you help me ?

Re: Need some help
 

IMHO they can help you.
I would suggest direct port injection.
4 nozzles right before the fuel injectors in the straight section of the plenum on the top side.
Flow level rule of thumb 1.5ml/min per HP.
If those 2150cc injectors is total flow over all 4, then you are likely in the 350 to 450 HP region. So jet wise you could start with 4x 0.4mm C jets or go right to 4x 0.5mm jets.
You need to be able to fully remap the WOT mapping to take full advantage of water methanol injection. Use a 50:50 mix per weight, so about 1l liter of methanol mixed with 0.8l of distilled water.
If your injectors are 2150cc/min each, you need to talk to specialists anyhow.

Re: Need some help
 

Thank you ,but at this time i'm at 500whp plus on pump gas.
this why i need help. where is Team Aquamist to save me with this problem..
I want to use Alcohol...

Re: Need some help
 

If you are not going to use E85, What are the reasons for the 2150 injectors? What is your power target?

Re: Need some help
 

Just looking to stop using C16 on the second program.
when i use the C16 and go to park for a few weeks i have to drain the fuel, so by going with Aquamist i know longer have to drain the fuel.

Re: Need some help
 

Horsepower I'm running 665whp C16 .
Looking for the same or better with Aquamist system on denatured alcohol .
I have faith in the Aquamist ...

Re: Need some help
 

You are probalby looking at 1200 to 2000 ml/min of water methanol mix at this power level.
Install a BIG tank for track work.
That is some serious flow for some serious power :-)

You might consider getting a air assisted spray system such as what riceracing is selling.
The work best with high boost and high flow.
Otherwise I have good experience with direct port injection with 4 nozzles right before the fuel injectors.

Re: Need some help
 

Thank you ... i'm thinking on the direct injection system will be the best system for me with the large tank , but what injectors should i start with ?

Re: Need some help
 

http://cdn2.bigcommerce.com/server24...f?t=1462179800
from the aquamist webshop :-)