Evo IX USDM fail safe (Mac valve) diagram?
I'm trying to figure out how to wire my mac valve for fail safe with a MBC on my evo IX (USDM)
I cant find a diagram, this is my last step so any help would be greatly appreciated. |
Re: Evo IX USDM fail safe (Mac valve) diagram?
|
Re: Evo IX USDM fail safe (Mac valve) diagram?
So I have my Mac valve connected to a constant 12volt source, the same as my boost gauge, wideband etc, Is this correct to have power to it at all times?
|
Re: Evo IX USDM fail safe (Mac valve) diagram?
It would be much better if you can connect the mac valve to a switched 12V, active only at the "pre-crank" or "run" ignition key position.
|
All times are GMT +1. The time now is 07:04 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.