no flow ??
 

ok well to start from the beginning the kit worked great when i got it. unfortunately i got rear ended 2 weeks ago now and my buschur 3' exhaust was ruined. as i wait for the insurance to clear up i am using my stock exhaust at the moment. so as for the kit i have my bottle filled over half way. gauge starts up normally and everything just like it did before but now if i throttle it im not getting any flow but instead the "B" led lights up. do you think this is because of my exhaust being changed out and not re-tuning it yet or could it be something else? thanks in advance guys

Unplug the jet from the engine, put the the system "test" jumper link and see if the jet sprays.

just checked it out and yea the jets are spraying.

Does the gauge show and reading under test mode?

yea the flow meter goes up just as if it would be as if i was driving it. now i also noticed my check engine light is on cause i put on my stock exhaust. could that have anything to do with it?

ok so i was driving to work today and decided to try it again and it worjed just perfect. ill assume i must have had a lot of air in the lines after installing the new gaskets and compression fitting and the test must have cleared it all out. yay =)