Re: Problems with set up
 

i'm going to try connecting the black and red wires somewhere else. i'll try the heater fan controls they are on key second position. i'll let you know how i get on

Re: Problems with set up
 

also check the red and green wire of the grey are not reversed at the fuel injector splice.

Re: Problems with set up
 

will do thanks. i have checked these i'll double check again. made the mistake of using a phase tester instead of a multimeter on the green injector wire and engine spluttered a bit (opened injector fully) and getting between 2-4 volts on the blue map sensor (will confirm)

also just to check, what readings should i be getting on the 2 signal points on the pump relay with the sys jumper in and out? meter points: black to earth in boot , red to 2 points or meter points: black to blue , red to red?

cheers

Re: Problems with set up
 

Can you measure pin16 while blipping the throttle.

Re: Problems with set up
 

hi Richard i've been away for a few days i check this later. thanks

Re: Problems with set up
 

Hi Richard I swapped the red wire for the controller as you suggested and it worked!!!! System is priming now putting it back together to take it for a spin make sure everything is OK. The wire I used turned out to be the low fuel light wire and wasn't a steady live

Re: Problems with set up
 

Thanks for the update.