FAV Voltage
Hi,
I am using an Aquamist FAV to control the WI on my system, controlled by my engine ECU. I am currently wiring it up & was about to connect it to +12V, but noticed the coil is marked 6V DC. What would be the best way to connect it to +12V and use a maximum of 50% duty from the ECU output (Low Side PWM) or I can connect to a +5V supply & use the full 100% signal, but then I guess the valve will only open 80% maximum? Thanks Neil |
Re: FAV Voltage
6V is for steady DC on/off operation.
12V with a PWM signal is ideal. |
Re: FAV Voltage
Quote:
|
Re: FAV Voltage
Quote:
Thanks Neil |
Re: FAV Voltage
25-35Hz is ideal
|
All times are GMT +1. The time now is 06:38 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.