Mazda RX7 FD3S Series 8 Setup
 

Hi Guys,

Does anybody have a wiring diagram for a series 8 rx7. I have seen diagrams for the earlier 8 bit ecus but not the 16 bit. Also what should be the setting for on-board trimmers and advanced system configurations.

My engine spec is: stock port 13B-REW, GT35R Single Turbo, 1680cc secondary injectors, 550cc primary injectors, OEM map sensor and apexi pfc ecu.

I plan to run preturbo and .6 at the boost elbow.

Thanks.

Re: Mazda RX7 FD3S Series 8 Setup
 

I found this might be the right one?

http://www.aquamist.co.uk/RX7-v3/99_...U_Pinouts2.jpg

Re: Mazda RX7 FD3S Series 8 Setup
 

thats the one. Do you have the pins for the last right connector?

Re: Mazda RX7 FD3S Series 8 Setup
 

Re-pasted. Sorry. see above

Re: Mazda RX7 FD3S Series 8 Setup
 

Great. So using the 8bit diagram. Would this be the correct wires?


http://i757.photobucket.com/albums/x...pspa2xcpfn.png

Re: Mazda RX7 FD3S Series 8 Setup
 

All wires must go to the appropriate pins on the 16-bit ECU.