NEW product... checkvalve jets
In order to minimise the dribbling effect immediately after the spray-off period, especially in jet location where there are pressure differences. We have introduce the full range of CVJ (check valve jets) for "direct port", multiple jets such as post IC, pre-IC and pre-turbo.
There is a 1-bar check-valve capsule inside the jet, the assemble is fully serviceable by end user. it is now available. It is now possible to use multiple jets to any location from one distributing manifold block (see 2nd picture below) without the worry of water inside the lengthy hose being emptied after system stops spraying. |
Re: NEW product... checkvalve jets
Some nice stuff there !
|
Re: NEW product... checkvalve jets
We are planning to life easier for those who wants to run multiple jets.
|
Re: NEW product... checkvalve jets
You mentioned before that you were looking at going up to 1/4 NPT for the nozzles, did this never happen?
|
Re: NEW product... checkvalve jets
|
Re: NEW product... checkvalve jets
Richard, i have some of those new nozzles, with them you included some sort little bronze swirly pieces that look like they go inside the nozzle :) What are these for?
|
Re: NEW product... checkvalve jets
The little swirly parts are for other flow rates in case the CV jets flow too much. They are part of the jet internals.
|
Re: NEW product... checkvalve jets
Quote:
Are these M8? Can't find it anywhere. Thanks |
Re: NEW product... checkvalve jets
Yes, they are the same as the standard jet, except about 7-8mm longer.
|
Re: NEW product... checkvalve jets
Quote:
Thank you. Are they worth it in case of a dual jet setup spraying both post IC, or just in case of a pressure differential? |
Re: NEW product... checkvalve jets
If you have an issue due to gravity or PD then they would help, but otherwise probably not needed.
|
Re: NEW product... checkvalve jets
Quote:
|
Re: NEW product... checkvalve jets
Hello, have to of check valve jets installed before throttle into intercooler pipe. Suddenly got "error" lights in my HFS4 controller and find out that one of two nozzle stopped spraying... So my questions - is there any options to make it working back (what should I check)
Thanks in advance |
Re: NEW product... checkvalve jets
Quote:
|
Re: NEW product... checkvalve jets
Quote:
|
Re: NEW product... checkvalve jets
If you have one nozzles suddenly stop working, Open it up and check for debris. This is the only cause. Make sure you do it on a clean table top. Make sure every o-rings are seated properly during reassembling.
|
All times are GMT +1. The time now is 11:23 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.