Wiring issue
 

I am trying to install this system in my car. It's an 06 Subaru sti but im having some issues. I have everything hooked up according to the wiring diagram but it doesn't seem to be getting a single from the injector. Do you have any idea what might be causing this?
Thanks
Ian Spark

Re: Wiring issue
 

Does the green led blink on the controller?

Do you have a digital voltmeter?

Re: Wiring issue
 

The green led does not blink. I can probably track down a volt meter.

Re: Wiring issue
 

Once you have the voltmeter, please let me have the readings on the following test points of the controller:

TP5, 8, 23

Black probe on ground pin (bottom left)

Re: Wiring issue
 

I checked the test

Re: Wiring issue
 

Points you said and they were no5 13.76v no8 13.76v no23 13.7v

Re: Wiring issue
 

Looks good so far.

The next step.

Please tell me what you see on pin 5 and pin 8 when you blip the throttle.

Re: Wiring issue
 

When I blip the throttle the voltage drops about the same for both of them

Re: Wiring issue
 

Pin 5 should be quite steady when blipping the throttle. Check the red wire of the grey harness is connected to a steady/fixed/switched 12V source.

Re: Wiring issue
 

I had a look at it and it is connected to the most steady source I can find it moves around about .05v when I blip the throttle is that good enough