Re: New water tank system
 

This planned already but we have not solved the unequal height caused the protruding bolt head if a water pump is assembled below. There will be a height difference of ~2mm. May be the rounded bottom of the tank wall provides a perfect solution.

We will supply four double length acetal stand-offs and four longer bolts.

http://www.aquamist.co.uk/tank/bolt2.jpg

Re: New water tank system
 

The cap has a label with instruction regarding venting. Cap is not vented from factory.

Re: New water tank system
 

From

http://www.aquamist-direct.com/806-6...-version-only/


The bracket is ergonomically designed to minimise installation time. Offering chassis floor or cross-rail mounting options. Four holes at the centre section of the bracket is intended for mounting an aquatec pump below.

Re: New water tank system
 

http://www.aquamist.co.uk/tank/warning.jpg



Uses little space...

http://www.aquamist.co.uk/tank/side.jpg

Re: New water tank system
 

I'm thinking out loud here

Will need to check for space but thinking I could also use this as a buddy tank
For my existing howerton mini r53 boot install, perhaps mounting direct to the outside wall

Sound possible for a retro fit?

Re: New water tank system
 

Outside wall?

The tank is 13" x 13" x 2.6", check the side panel of the boot.

Here is a trial fit to a smart car:
http://www.aquamist.co.uk/tank/smart.jpg

Re: New water tank system
 

http://howertonengineering.com/mini/

Using outside facing sheet metal as the fixing point.

The sloping seat back is the challenge on a r53

Will be a very tight fit,

Might work if on slight angle or offset say -10 degrees from vertical

Re: New water tank system
 

I have emailed you and jeff some pics of my mock up
Will be better than a thousand words here
As was struggling to resize on iPad