"W.Injection" Staying partially lit
Richard, could you take a look at this ? I saw your post below about adjusting FSDL that didn't help in my case. This has been an issue since I got the unit (about a month ago). Temperature doesn't seem to be a factor here. Does it hot or cold. This doesn't impair the unit, everything works like normal. My concern is when the unit is out of warranty and something goes wrong.
http://i2.photobucket.com/albums/y15...pscqnlmfa3.jpg Referencing post http://www.aquamist.co.uk/vbulletin/...ead.php?t=2730 |
Re: "W.Injection" Staying partially lit
Not sure what caused this, Can you disable the failsafe (DFS) ans see if it cures it. Also put duct tape on the back on gauge. Condensation may cause this.
|
Re: "W.Injection" Staying partially lit
Quote:
|
Re: "W.Injection" Staying partially lit
The top yellow led is solely responsible for failsafe. I doubt failsafe is the cause.
Most likely to be a dry joint. Can you take a Hi-res picture and send it to Richard at aquamist.co.uk I like to examine a few surface mount components. If I see a suspect joint, can you solder? Just needs re-flowing. |
Re: "W.Injection" Staying partially lit
Im assuming you want me to take a high res photo of the back of the dash gauge's circuit board? I can probably re-solder, however will this void the warranty?
|
Re: "W.Injection" Staying partially lit
Yes, the back of the gauge circuit board. The bezel unscrews.
I will take care of the warranty for you. Provided oyu do drop a big blob of solder onto the circuit board. |
Re: "W.Injection" Staying partially lit
No worries sir im pretty good with the ole soldering iron! I'll get the pictures tonight
|
Re: "W.Injection" Staying partially lit
Still have not received the picture.
|
Re: "W.Injection" Staying partially lit
Quote:
|
Re: "W.Injection" Staying partially lit
Hi Richard YGM!
|
All times are GMT +1. The time now is 11:45 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.