I was following the priming instructions, but I do not get power to the pump. I checked the connections with a multimeter. First of all, I have verified my ground and I have 12v from the battery. At the relay connections, I have verified 12V from the battery and 12V from the controller box while the jumper is in SYS position. The output of the relay shows 0V, but I believe it should be 12V when the signal from the controller box is 12V. Do I understand this correctly?
See this youtube video for a demonstration of my measurements:
http://www.youtube.com/watch?v=61NKGOpdBtk
I purchased 2 kits during the GB, one for myself and one for a friend. With your input, I will try using my friend's relay (he is not installing his system for another week or two). Any other suggestions? Thanks!