Quote:
Originally Posted by Ilkka
So there is no way to see the absolute flow from the flow gauge? Why is there a 0 - 400 ml/min legend then?
|
It is possible if you calibrate the sensor against SC to give some representation of the voltage against flow. The 400ml is just a scale or multiple of.... The flow sensor is design for use with the failsafe, it is a simple flow monitoring system, Not intended to read absolute flow. If you want a true and calibrated flow sensor, I can supply one that is calibrated and signal conditioned to your setup. The sensor is ?80.00 and calibration will be ?60.00 on top.
As I mentioned before, the raw signal (pulsed) from the sensor can be used. But you can make your own decoder to make the output absolute.
Quote:
Originally Posted by Ilkka
I can see only 8 bars on the gauge? Where is the 9th bar?
|
Correction, I meant the 1st to 8th. Sorry.
1st = 10-20%
8th = 80-90%