Re: HFS-3 Eaton Charged 1600
Thanks for turning it around so fast.
I really cant understand what was going on, those ate the 4 joints that I thought looked suspect, one of them had a large dull area in the joint.
When I tested it I tested the power coming out of the connector and the power on the board, at the solder joint and that's where I saw my differences, unless it was the molex plug making connection when I spun the board over to test both sides of the joint? I'll replace the connector and loom aswell, see if it sorts out the issue.
Oh and I have a little question regarding the Ecu loom and the power +12v connection (red wire) earlier in the manual it says to use a switched 12v and later on it says to use the positive on the injector? I take it you need the positive on the injector as that's the only way it's going to see the duty. Just want to make sure so I don't damage anything.
|