Re: HFS-6 problems
Hi Richard, Thanks for the prompt reply !
Problem #1
The water tank is almost full, and has been for some time, since before the level sensor was connected. Which is why I think there is a fault. It is installed right way up etc. I am wondering if I can reset or bypass the system. Does what I have described tie in to when you unplug the blue RJ45 and have the system working ok ?
Problem #2
I'll go out now and fix that issue. I'm getting pretty good at pulling the wife's car apart these days...lol.
The only cable I was going to run off the #2 run position will be the red wire to the 4 way power connector on the controller box ? will the yellow RJ45 connector be needing to be connected to the #2 switched positive as well ??
Thanks again.
|