[Arthurwiljami]

I remembered the flow bar had 10 bars and not 8 so I'd say it must've been 6-7 bars what it showed before the flow was reduced and failsafe activated.

I red the manual but as english isn't my native language I don't quite understand how do I "calibrate" the WL and WH. It says in the manual "once SC is calibrated" I can set the WL and WH but I have tried those in different positions and it doesn't seem to make any difference?? Does WL mean too little water is flowing and WH mean too much water is flowing and the "B" lit up ?

Richard can you simplify to me how do I adjust the WL and WH? At the moment the WL is between 11-12 o'clock and WH is 1 o'clock. SC is adjusted to 2 o'clock if it matters. I have dual nozzle 0.9mm and 1.0mm.

I think I should take a video to show how the gauge behave because it's difficult for me to explain it in words.