Thread: Tap/thread size to add 4mm fitting to direct port manifold
View Single Post
  #5  
Old 17-06-2013, 06:42 PM
5mall5nail5 5mall5nail5 is offline
Member
  
Join Date: May 2010
Posts: 31
Default Re: Tap/thread size to add 4mm fitting to direct port manifold
Quote:
Originally Posted by Richard L View Post
Do you have a 6-port hex manifold already? The 7th jet can be installed at the blanked-off end, you just need a 1/8 to 4mm fitting. I also recommend an inline checkvalve to stop the fluid commutating between the two location.
I have a 6 port already yeah. I already have an extra M5 4mm compression fitting so I'd really like to install it but I only have a M5 x 0.8 tap set so I just wanted to see if that was the right size. I have check valves at each nozzle and the 7th nozzle is your new check-nozzle in 0.3mm size.
Reply With Quote