All I know is that Aquamist seems to work fine now, temporarly i have installed a secondary meth kit to double check WMI and my AFRs and everything with both of them, and in the engine keeping just Aquamist
They dont run in parallel, just one enabled at one time. I was reducing the quantitiy of meth injected by reducing the size and number of injectors, that's why i ended with a single 0.5 now. IAT is dropping ok
With both systems, i saw HIGH ENGINE LOADS and 0.73 lambda with every combination of injectors (big, small, dual, single) and every combination of meth mix (30%-100%)
I dont know what is causing this, but if i will find out the answer i will know what to do next.
I target 0.8Afr (11.76) and this is also what i get on pump, on meth i target also 11.76 and i go down to 10.7 and high engine loads (240 instead of 170), any ideas what is the reason for this ?