For Configuring the MAP sensor
Hi, My car is Audi RS4 B5 2001. I check my MAP sensor and HFS4-V2 manual that confusion. My MAP sensor is the signal which the sender generates is a pressure-proportional voltage ranging from 0 to 5 volts. At atmospheric pressure (14.7 psi or 1.01 bar at sea-level), the voltage is approx. 1.88 volts. The absolute maximum pressure reading is approximately 2.55996 bar absolute (22.45 psi), which should read approximately 4.76 volts.
The manual P21 Configuring the MAP sensor type: (Three types of MAP sensors can be selected)
(a) Absolute (default): This can be used for any sensors with 0-5V output, such as throttle position, mass air flow sensors etc.
(b) 2-bar MAP sensor: Select this link to convert a 2.5 bar MAP sensor to read from atmospheric to 22psi full scale 0-5V output.
(c) 3- bar MAP sensor: Select this link to convert a 3.5 bar MAP sensor to read from atmospheric to 36psi full scale 0-5V output.
Which one is my car setting ? (a) or ( b). Also what is different between each ? Thanks
|