Re: System will not trigger from IDC
Looks as though it has all been successful. Takes a few rpm to get it triggered with the trimmer fully counterclockwise but I'd say this is due to the largish injectors (750cc). Should I use the 1.5x multiplier to get it to trigger a little earlier as I'm only at around 24.5% idc at 8psi boost. I don't have the actual duty cycle data logged but used a calculator that uses ms and rpm to come up with the % figure. I did have to turn the trimmer back to get it to start injecting at 10psi. Is there a typical boost pressure to use for a starting point or does it change with individual vehicles?
Also am I able to data log from the aquamist if I wire it into one of the ecu's inputs? I noticed in a couple of other threads where a yellow wire was mentioned for this.
|