This threat shows install pictures:
http://www.rx7club.com/auxiliary-inj...-pics-1031140/
A diagram:
http://www.mx6.com/forums/2g-mx6-for...ml#post2606465
A video:
http://youtu.be/8Lizxy3XIY8
Depending on pressure and flow, you get median droplet diameters of half the total volume in the range of 30-80 microns with air assisted nozzles while hydraulic nozzles are more in the range of 200-500µm. The media diameters over total number of droplets are in the range of some five to 5-20 µm vs. 100-200 µm. These numbers are not hard numbers as every manufacturer and type of nozzle acts a little different.
there is a reason you go for air assisted if smallest droplets are a main factor for performance, e.g. Paint spray, cooling in manufacturing processes, e.g. Plastic milling, or humidification systems.
It has its merits, I'd therefore not slag it off just because Snow XXX does not sell it.
Why would you not even consider a small air to air cooler? The benefits for performance would be tremendous.
Regards
Marko