Nozzle size
Hi!
Long time lurker, first time posting. I bought a brand new HFS-6 over 6 years ago and never installed it. My build took a different direction lately and I think its time to put this kit to use.
I'm kinda lost on the nozzle size and location. Before I drill and start making holes I wanna make sure I got this right.
A little bit about my car, 2004 G35 coupe twin turbo with Brian Crower 4.2L Stroker.
I have ID2000 injectors and I'm planning to run 20-24psi.
Piping goes as follow Turbo>Intercooler>BOV>MAF>Throttle body.
Can someone please let me know if I got this correctly if I'm planning to run a 50:50 meth/water with 15% to fuel?
2000cc x 6=12000
12000 x 0.15=1800cc
160psi - 20~24=140~136psi.
The manual shows the 1.00mm flows at 550cc at 140psi
Now this is the part where I'm confused.
If I got the above numbers correct, does that mean I need 3x1.00mm nozzles at a total of 1650cc (closest i can get to 1800cc)?
If I do need 3, where do they go? After the MAF before Throttle body?
Much appreciated.
Last edited by SAMzG35; 06-06-2018 at 02:15 AM.
|