I've been running WI for about 6 months now with no major problems (that Richard couldnt sort out :wink: ) but have recently started fitting a charge cooler kit
as below (not my car)
As you can see, I'm a bit restricted as to where to now put my jet. The piping is quite thin aluminium and so not best suited to a bend location.
space and 'flat' wise the easiest loaction would be pre-IC, also the last bend after the IC is almost on top of the plenum etc so a little worrying (and I'd have to drain the charge cooler etc and remove the heat exchanger to drill it)
dont really want to 'suck it and see' as I'll end up with a hole in my pipe if the chosen point is no godd.
what the suggestions of the knowledgable ones on here? Richard?
thanks in anticipation
Perry