I think the 0.5mm jet is a good start. I based the WI rate by your power output of 180whp. Not sure what that would translate it flywheel HP - I guess it will be around 220-230HP?
You will require approximately 500-600cc/min of fuel per 100BHP. if you are injecting 1.1 litre of fuel /min then one 0.5mm jet will equate to about 20% of water to fuel ratio.
We normally recommend between 10-15% but due to your lack of intercooler and making boost on top of the standard compression ratio(?). I think 20% is about right.
Please post your results when possible.
__________________
Richard L
aquamist technical support
|