Hi!
Has anyone tried using a fuel injector as FAV?
I found an injector with close spec to whats needed in terms of pressure and flow.
The question is if it can handle water corrosive properties and if it will open consistently at pressures slightly over its rating.
Also the pressure drop over the injector might be larger.
This injector also has a replaceable filter built in to it.
Nominal Flow Rate – 1065cc/min @ 3.0 Bar (43.5 psi) Using Gasoline at 52 Degrees C (125 Degrees F)
Maximum Differential Fuel Pressure – 10.0 Bar (145.0 psi)
Something like this:
