[Peter_k]

Hi Folks

After several hours on google digging around I’ve hopefully got the wiring sorted.

The wiring is as follows

1. 4-way Power-in connector:
- Red ................ Switched 12V (IGN SW#2) ------------- to fuel injector (+)
- Black ............... Chassis ground ---------------------------to cigarette lighter (-)
- White .............. Chassis ground ---------------------------to cigarette lighter (-)
- Purple .............. Head lamp switch (optional) -------------not wired yet
2. Signal to the yellow RJ45 connector:
- Red ................. Ignition switched 12V --------------------to fuel injector (+)
- Green ............. Fuel injector (-) pin ------------------------to injector 1 control
- Blue ..................MAP sensor (optional) -------------------to manifold pressure sensor signal input

Both red wires are connected to fuel injector positive

I’ve ran the Power-up procedure as shown on installation manual, all lighting sequences are good apart from green led on the controller should flicker this doesn’t happen.

The water pump doesn’t start, power is getting to the relay but not past the relay, I’ve replaced the relay with a new one and still no power.

Water tank is full and the sensor arm is floating in the up position

Any help regarding this would be very appreciated.