View Single Post
  #2  
Old 13-06-2011, 10:53 PM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,936
Default Re: HFS6 and misfire code.

Can you tell me if the system is spraying at part throttle when the misfire occurs. Set the trip point higher or set the "offset" lower. It could be caused by the system blown out the sparks.

The aquamist will stop immediately when it goes below the trip point. But the gauge migh still display flow due to the turbine in the flow sensor runing on. Also The bargraph has an inbuilt rollomh average low-pass filter so the signal send to the gauge lingers on a bit.

Watch the amber led on the controller, This is a more accurate way to determine the stop/start of the spray.
__________________
Richard L
aquamist technical support
Reply With Quote