Re: Pump is activated after a while when the motor is not running
It is important that the red wire of the grey harness is connect to a +12V source with the following:
ignition key at "off" ................ no 12V
ignition key at "accessory" ............. no 12V
igntion key at "pre-crank" ................ 12V
ignition key at "cranking" ............. 12V
ignition key at "run" ............. 12V
You can use use a DMM on test pin 5 of the controller to confirm this.
__________________
Richard L
aquamist technical support
|