Thread: Mazdaspeed 3
View Single Post
  #6  
Old 13-04-2015, 10:29 PM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,936
Default Re: Mazdaspeed 3

Quote:
Originally Posted by jdraps13 View Post
Okay thank you, so i soldered the stuff as the diagram says except soldered the 3 instead of 2 for my 3 bar map sensor, and set up the jumpers as diagram said but was missing one so pulled the one off PRK and used it instead is that okay?
Do not follow the jump on the previous diagram, they are not accurate. Go by the gold dots (default). Have you solder linked the x2.5 and cut x1?
__________________
Richard L
aquamist technical support
Reply With Quote