Re: Control board not commanding FAV to open .
As for the trunk harness, I think the clip of the connector was bent on installation, which is why it will not hold into place correctly.
Yes I was using the aquamist in tank filter, and I have been using a third party tank, and as Ive begun to really run through the list of issues, I am starting to believe it may be the tank. Specifically a sealant I used on the outside of the tank adapter as the hole drilled there was not perfect and caused a small leak. It is formulated of 50% Toulene, which from my brief research is a hydrocarbon... so potentially my issue. I will have to replace the tank and see if that solves the issues.
Do you have a recommendation on tanks? I see you sell a 10L dual tank, does this come plug and play with the in tank filter and level sensor already installed?
My plan for now:
1) I ordered 100% meth from Torco, I will soak the valve for a few hours in the 100% meth to draw out any hydrocarbon contamination. Then let it dry out for a couple days.
2) Replace my tank
3) Purge the system with distilled water, then 100% methanol
4) Reinstall FAV and ensure its no longer swollen and everything runs correctly
5) Reintroduce new batch of 50:50 boost juice, hopefully all is solved then
|