View Single Post
  #10  
Old 15-09-2013, 12:25 PM
jontysafe jontysafe is offline
Junior Member
 
Join Date: Aug 2013
Location: Marlborough
Posts: 2
Default Re: injecting hot side

Hello there, I still haven`t pulled the trigger on my HFS3 install but I was thinking exactly the same as Stevieturbo. I was going to go for one pre-intercooler jet and one post intercooler jet. In an ideal world 100%water pre and 50/50 water/meth post, but more than likely 60%Water40%Meth in both or it gets complicated.
A stated the boiling point of water is affected by pressure:

http://www.engineeringtoolbox.com/bo...ter-d_926.html

From what I understand though not enough on the hot side to be a problem?

If we take 14.69psi as atmospheric pressure, do I understand this correctly, in a turbo charged engine running 20psi I should read graph across at 35psi? Then the boiling point is 126 degrees C. Hardly an issue?
Reply With Quote