View Single Post
  #14  
Old 02-01-2016, 02:22 AM
jondee86 jondee86 is offline
Member
 
Join Date: Dec 2015
Location: New Zealand
Posts: 78
Smile Re: JET PLACEMENT FOR AIR FLOW (POST-MAF)

At the moment I am thinking of something like this...



I prefer a "bolt-on" solution rather that cut and weld, and I'd rather be
fabricating ducting that runs out in the open rather than hidden in behind
other parts. Just makes it easier to work on

This fitting would bolt in place of the OEM inlet neck and the airflow into
the plenum would be similar in direction to the airflow from the stock inlet.
It does mean that I will have two 90 deg bends and one 90 deg elbow in
the ducting, but when I look at pictures of other supercharger installations
I see a lot worse !!!

Cheers... jondee86
Reply With Quote