Re: problems with FAV solenoid - no work, but getting very hot!
Richard,
When I connect pins 1 and 2 - I got system fully functioning, with maximum flow.
Also I have checked both black and white wires on molex - there is 0.1Ohm impedance between them and chassis ground.
I can try to solder one more transistor and check results.
Also, when I shortcut pins 1 and 2 the system works on full load for few seconds and then the 'water level' warning appears - why?
Regards,
Alexey
__________________
Alexey K.
I drive Peugeot 207 RC 225 bhp with HFS-3 onboard / tuned ECU
|