HFS-4 came in faster from GB than a package from Amazon two states over. I tried to install the washer tank and evidently I got the tank from the Cobalt SSNA, instead of the SS/SC. So $50 down the drain. Found an SS/SC driver that had one for $20+shipping, and got some pictures of how it mounts, so i will get it installed when it comes in.
To Richard or anyone reading, with the shape of the washer tank (see below), would the place the washer pump is at be a good place for pickup? There is a half circle shape at the bottom of the tank where the pump mounts, and there is already room for 6mm hose to run. I would mount the low level sensor halfway up, about where the connector for the pump is, and run the wiring up that indention.
I will use the intank filter if it isn't too long, or the AEM inline filter if there is worry about debris.
