Re: HFS-3 Tests O.K., but No Bar.Graph During.Operation
Honestly I don't know, could it be the electrical portion of the flow sensor assembly?
I know it was clipped onto the flow tube solidly, and am assuming there's no directionality to the clip itself, so that's the only thing else I can think of that would give me actual flow without relaying the info to the gauge.
Is there a test that I can do to see if I'm getting the proper electrical signal through the yellow harness, from the pickup (clip) to the controller connector?
Or can you send me another flow sensor yellow harness when you send my parts back, that I can try, and then send you back this one that's in the car?
Thanks, and let me,
Mark
|