[dlheman]

I think I saw your CX-7 on CX7modders facebook page. At least from your description of your CX-7 suggested it. Are you in Brisbane?

But anyhow the guideline of 1.5 x engine horsepower is a pretty good starting point.

I recently completed HFS4v3.1 install and setup for my VW Golf MK6 1.4TSI, and ended up with 1.5 x engine horsepower of total wmi flow. Which nets about 340cc/min. No drama at all and even managed to get to target boost level set by REVO by injecting 50cc/min pre-compressors (just to have super cold air intake effect).

And some interesting note; I can only inject 100cc/min when using 'lesser' wmi kit or else the engine will get choke with too much wmi too soon.

Let us know how you go because I am quite familiar with the 2.3 DISI engine as I have a modded CX-7 also.