Anyone any interest in this ?
After a little grinding and filing
I'm not saying it's perfect, but its cheap.
I had it cut from 4mm thick aluminium and all legs are 4mm thick also.. This one is 102mm OD so it's a snug fit inside my air intake pipe.
I made the external legs 10mm, these can be cut down. Idea being drill a hole into the silicone tube and these legs will secure the fitting from going anywhere.
Again cheap and easy to use.
Just trim and adapt as necessary. Could get them made in other diameters if anyone interested ?
Or could have legs reduced to a smaller size, I was just paranoid about strength so opted for 4mm. 2-3mm would probably do fine.
This is my first attempt at pre-compressor, although I'm also spraying a lot pre throttle as well. Centrifugal supercharger application