So back home...It's been a loooong day.
A 1hr job turned into an all day. Was meant to just install new pre throttle body pipe and then start setting up water install.
8am..Drive to mates house. 9am have everything stripped . 10am...many swear words and new pipe installed.Test water system before on throttle pipe using jumpers as decribed to prime pump but not disconnecting the 6mm hose before the ......thingie goes tpo the small cable
No joy... Pump doesn't seem to do anything. Light does green on dash but does not blink.
Then jumpers back to stock.Tried full anti clock on threshold and full clock on gain setting still nothing even if car if blipped light does not flicker gauge or board .
Got tired so plugged it all together filled up with straight water.
Try start car again and find battery so flat car doesn't even start to swing :roll:
11am move pipe to stop hitting cooling fans ....nothing heavey duty cable ties can't do
1am ... Battery finished charging and went for a test drive with pump off.
No problems, pipes not working loose no annomolies so getting happier
2pm. Went logging. pump off. Ambient was 27c intake temp 39c . 12c above ambient. Not too bad without meth. Max timing pull -7.5c.
Turned on pump stock 12oclock both threshold and gain. 2 runs and light on dash does not blink.
Couple more runs and finally once threshhold at full anti clock and gain on full clock only rougly at 17-18psi does dash light kick in and strat flashing green ...yay
After many runs doesn't use much water but it is going down though.
Logs on final run .Ambient still 27c. Intake 31c so 4 degrees above ambient. Getting there :roll: Timing still pulling -3 at max so better but obviously not great.
Unfortunately I am away tomorrow but will try prime the pump again next weekend but doubt it will make a diffeance think it does have water and is primed. Just doesn't seem to be adjusting the way I expected. My mate with same K04 setup and this kit also same installer has his setup on 11am threshold and 2pm for gain.
I don't think this is a Aquamist problem but more likley something not correct on the original install that was done even though the installer has done many W/I installs and one hfs3 already. :cry:
Just wish I could get it to work correctly...Just need time I guess.:cry: